Restoration phone support available around the clockCall (877) 361-7453

Rooms and affected areas

Clovis, CA

Attic Water Damage Cleanup in Clovis, CA

Our building recovery team finds and dries moisture in attic insulation, framing, and ceilings after roof leaks, condensation, or plumbing failures.

  • Restoration phone support around the clock
  • Residential and commercial loss response
  • Measured extraction, cleanup, and drying
  • One restoration team from assessment to dry standard

Call (877) 361-7453Browse services

Signs to look for

When to call us for attic water cleanup

As materials are evaluated, if you notice any of these problems, call us before water has more time to spread into nearby materials.

Insulation is flat, matted or darker in one area

As materials are evaluated, dry attic insulation is fluffy and even.

Dark staining or streaks on the underside of the roof decking

Across the affected building area, water tracks down the sheathing before it drips.

Rusty nail tips or shiny wet fasteners overhead

Across the affected building area, roofing nails poke through the decking and rust first because condensation and leak water both collect on metal.

A stain on the ceiling below that is smaller than the wet area

From the building building assessment, insulation soaks up water and spreads it sideways before any of it reaches the drywall.

The attic smells earthy or sharp when you open the hatch

As materials are evaluated, attic heat drives odor out of damp materials fast.

Daylight or a wet ring around a pipe on the roof

As materials are evaluated, a cracked plumbing vent boot is one of the most common attic leak sources.

What happens

How we handle attic water cleanup

Our building recovery team adjusts the work to what got wet, how far the water traveled, and which materials can be saved.

A safe path across the attic before any work starts

Across the affected building area, we plank a walkway over the ceiling joist tops so nobody steps between them onto drywall.

A moisture map taken from above and below

As materials are evaluated, we read the decking, the framing and the top of the ceiling drywall, then read the same ceiling from the living space with a moisture meter.

Source identification at the roof and inside the attic

For sound structural recovery, we separate roof water from attic plumbing and from a leaking condensate line.

Wet insulation removed and bagged in place

For sound structural recovery, saturated blown in cellulose and matted fiberglass batts are vacuumed or bagged at the source so debris never travels through your house.

Dry insulation protected and left alone

As materials are evaluated, we do not clear an attic wholesale. For sound structural recovery, insulation outside the wet area gets covered and stays, which keeps both cost and disruption down.

Stored contents triaged and moved out

As materials are evaluated, boxes, luggage and seasonal items come down to a staging area and get sorted into dry, dryable and finished.

Talk with a restoration specialist

Water loss in Clovis, CA?

Describe the source, the impacted rooms, and when you first noticed the damage.

Call (877) 361-7453

What to expect

What to expect from our building recovery team

As materials are evaluated, here is how we usually handle attic water cleanup near Clovis, CA.

  1. 1

    Tell us where the stain is and when it appeared

    From the building building assessment, say whether it followed rain, whether the air conditioning was running, and how you get into the attic.

    Your call
  2. 2

    Clear the room under the wet ceiling

    Across the affected building area, keep people and pets out of the space under the stain and look at it from the doorway.

    +5 minutes
  3. 3

    Attic entry and a safety read

    As materials are evaluated, a technician planks a path, checks whether any ceiling section is carrying wet insulation weight, and confirms nothing electrical up there is wet.

    On arrival
  4. 4

    The wet area gets measured, not guessed

    Across the affected building area, readings run outward from the obvious patch until the numbers match dry attic material.

    First hour on site
  5. 5

    Insulation out and contents down

    For sound structural recovery, soaked insulation is bagged at the source and stored items come down to staging.

    Day 1
  6. 6

    Equipment set high and aimed at the decking

    Across the affected building area, the wet section gets contained or fed with dry air ducted from the conditioned space, then air movers work the rafter bays.

    Day 1, evening
  7. 7

    Readings tracked at decking, joist and ceiling

    For sound structural recovery, the same three points get read daily, because they dry at three different speeds.

    Day 2 to 4

Understanding the cost

What can affect the price

As materials are evaluated, we explain the recommended work and price before you approve the job. As materials are evaluated, these examples show what may change the estimate.

Common situationWhat the estimate may includeTypical range
Small attic leak cleanup caught early, insulation removed from one areaFrom the building assessment, national estimate. Across the affected building area, assumes clean roof water, easy hatch access and a ceiling below that dries in place.$500 to $1,500
Wet blown in or batt attic insulation removal and disposal, per square footFrom the building assessment, national estimate. Across the affected building area, vacuum removal of loose fill sits at the top of the range, batts at the bottom.$1.00 to $2.50
Attic drying with equipment in the attic space, three to five daysFor sound structural recovery, national estimate covering air movers, dehumidification and daily readings at decking, joists and ceiling.$900 to $2,500
Attic cleanup with insulation replacement and the ceiling below dried in placeAs materials are evaluated, national estimate for a room sized wet area. Across the affected building area, roof repair is priced separately by a roofing contractor.$2,500 to $7,500
Blown in insulation replaced to code depth, per square footFrom the building assessment, national estimate. As materials are evaluated, depends on the R value specified and whether baffles and air sealing are included.$1.50 to $3.50
Attic contents pack out, sorting and cleaning, per itemFor sound structural recovery, national estimate per item handled. Across the affected building area, most attic contents are either fine or finished, so the count is usually low.$20 to $150
  • Attic height and access
    Across the affected building area, a walk in attic with a real staircase is normal labor.

  • How much insulation has to come out
    Across the affected building area, removal is priced by area.

  • Insulation type and the R value going back
    As materials are evaluated, replacing to current code depth costs more than matching what was there.

  • Whether the ceiling below is saved
    For sound structural recovery, drying a ceiling from above is inexpensive. As materials are evaluated, removing and replacing ceiling drywall adds material, texture matching and paint across the whole room.

  • How long the water ran before it was found
    For sound structural recovery, a leak caught after one storm is a drying job.

  • Source type
    For sound structural recovery, a cracked plumbing vent boot is a small roof repair.

Why timing matters

What can happen when the area stays wet

For sound structural recovery, water can keep moving into nearby materials even when the surface looks dry.

Wet insulation stops insulating

Across the affected building area, insulation only works when it is lofted, and cellulose that has soaked and packed down stays packed down.

The ceiling below can fail under the weight

Across the affected building area, water plus saturated insulation adds real load on top of ceiling drywall.

Roof decking fails in two different ways

As materials are evaluated, plywood sheathing separates in plies once it stays wet, and the layers do not bond back.

Attic odor rides the stack effect into the whole house

For sound structural recovery, warm air rises out of a house and pulls attic air down through light fixtures and the access hatch.

Helpful service information

What to know about attic water cleanup

From the building assessment, start with the short explanation. For sound structural recovery, open a card if you want a little more detail.

What is happening inside the property

For sound structural recovery, that single fact explains why attic leaks are found late.

Read the explanation

From the building assessment, the attic is the only room in a house where water lands on insulation before it lands on anything you can see.

How the next step is decided

From the building assessment, a healthy attic exchanges air from the soffit vents up through the ridge vent.

Read the explanation

As materials are evaluated, attic drying is a ventilation problem as much as a water problem. From the building assessment, a healthy attic exchanges air from the soffit vents up through the ridge vent.

What may change the work

As materials are evaluated, roof decking, rafters, trusses and the ceiling drywall below normally dry in place when we reach them in the first days.

Read the explanation

As materials are evaluated, what can be saved up there is fairly predictable. As materials are evaluated, roof decking, rafters, trusses and the ceiling drywall below normally dry in place when we reach them in the first days.

Help near you

Attic Water Damage Cleanup near Clovis, CA

Choose your area below, or call (877) 361-7453 and describe what happened.

Common questions

Questions about attic water cleanup

How much does attic water damage cleanup cost?

From the building building assessment, nationally most attic jobs land between $500 and $7,500. Across the affected building area, a small leak caught early with insulation removed from one area runs $500 to $1,500.

Does wet attic insulation have to be replaced?

As materials are evaluated, cellulose does. As materials are evaluated, blown in cellulose mats down and does not go back, so it is replaced.

Can my ceiling be saved, or does it have to come down?

For sound structural recovery, most ceilings are saved when we can dry them from the attic side. From the building building assessment, removing the wet insulation above the drywall is what makes that possible.

How long does it take to dry an attic?

From the building building assessment, usually three to five days after the insulation is out. For sound structural recovery, roof decking dries faster than you would expect once air is moving across its underside, since the shingles cover the top face.

Is it safe for me to go up in my attic to look?

For sound structural recovery, only if you can stay on framing and see where you are stepping. Across the affected building area, never step between ceiling joists onto drywall, and never onto a section that is holding wet insulation.

How do you find where the roof is leaking?

As materials are evaluated, we trace the wet trail upward on the underside of the roof decking and around each penetration.

As materials are evaluated, my attic is wet but there has been no rain. What is it?

For sound structural recovery, four common causes, and the most frequent one we find is a bathroom exhaust fan ducted into the attic instead of outside.

Talk with a restoration specialist

Water loss in Clovis, CA?

Describe the source, the impacted rooms, and when you first noticed the damage.

Call (877) 361-7453

Areas we serve

Water-damage help near Clovis, CA

Our building recovery team evaluate homes, businesses, and managed properties throughout Clovis, CA and nearby communities.

View the area on Google Maps
Call (877) 361-7453